By continuing you are agreeing to our use of cookies Learn more

langue en Cessna - 03/05/2019

Measuring Dent, Gouge or Scratch Depths Using a Feeler Gage

Cessna Aircraft Company Customer Service Engineer explains how to use feeler gages to take measurements of dents, gouge's and scratches.

ON THE SAME THEME

langue enMeasuring Dent, Gouge or Scratch Depths Using Drill Bits or Wire Gauges

Measuring Dent, Gouge or Scratch Depths Using Drill Bits or Wire Gauges

langue enSanded or Damaged Rivet Inspection Prior to Aircraft Repainting

Sanded or Damaged Rivet Inspection Prior to Aircraft Repainting

langue en750 Viewing Rudder Position Sensor Data in IMT

750 Viewing Rudder Position Sensor Data in IMT

langue enModel 750 Viewing IAC-AFCS Fault Codes in IMT

Model 750 Viewing IAC-AFCS Fault Codes in IMT

langue enModel 750 Performing Rudder Actuator Test in IMT

Model 750 Performing Rudder Actuator Test in IMT

langue enModel 750 Performing Elevator Trim Interface Test in IMT

Model 750 Performing Elevator Trim Interface Test in IMT

View All Videos CIVIL AIRCRAFT

MORE VIDEOS CESSNA

langue enModel 750 Center Wing Transfer Switch Operation

Model 750 Center Wing Transfer Switch Operation

langue enModel 750 Accessing APU Fault Codes

Model 750 Accessing APU Fault Codes

langue enModel 750 Fuel Boost Pump Operation

Model 750 Fuel Boost Pump Operation

langue enCessna Single Engine Wing Replacement Considerations

Cessna Single Engine Wing Replacement Considerations

langue enCitation Mustang Engine Desalination Rinse

Citation Mustang Engine Desalination Rinse

langue enCitation Mustang Engine Wash Procedure

Citation Mustang Engine Wash Procedure

View All Videos Cessna